為了美觀性，也為了通透感和亮度，家里的浴室與廚房選擇了推拉玻璃門作為隔斷。下面濟南玻璃門廠家來講講玻璃門常見的5個問題。

For the sake of beauty, transparency and brightness, the bathroom and kitchen at home choose sliding glass doors as partitions. Next, Jinan glass door manufacturer will talk about 5 common problems of glass doors.

一、異常的聲響

1、 Abnormal sound

倘若開關門時有聲音，玻璃門下垂，很可能是地彈簧壞了。一旦發現，須及時處理。不然，地彈簧和門框會嚴重毀壞，甚于玻璃門也會因壓力過大或摩擦力過大而出現破裂和受損。輪滑是玻璃門的關鍵零部件，倘若出現故障，不但使用麻煩，并且會產生噪音。

If there is a noise when opening and closing the door, and the glass door droops, it is likely that the floor spring is broken. Once found, it shall be handled in a timely manner. Otherwise, the floor spring and door frame will be seriously damaged, and even the glass door will be cracked and damaged due to excessive pressure or friction. Wheel slide is a key component of glass door. If it fails, it will not only cause trouble, but also generate noise.

二、拉手脫落

2、 Handle falls off

一旦使用時間太長，拉手是比較容易壞的，因?yàn)樗匠＝佑|得多，會承受很大的重力，長時間的磨損很容易讓它脫落。維修時，先將玻璃門取下，再拆換為新拉手。

Once the handle is used for too long, it is easy to break, because it usually contacts too much and will bear a lot of gravity, and it is easy to fall off due to long-term wear. During maintenance, remove the glass door first, and then replace it with a new handle.

三、玻璃門不能正常滑動

3、 The glass door cannot slide normally

門扇使用一段時間后，也會出現一些或大或小的問題，有時候會感覺到很鈍感，通常是彈簧出了問題，那么只需拆換一個承重性較好的彈簧便可。查看其滑槽內是否有雜物，使其不能正常滑動。，清理滑槽內的雜物，看它是否能正常滑動。假若不行，查看滑槽是否生銹。在這種情況下，往滑槽內添加一些潤滑劑類的東西或者是對滑槽除銹。

After the door leaves have been used for a period of time, some big or small problems will also occur, and sometimes they will feel very dull. Usually, there is a problem with the spring, so it is only necessary to replace a spring with good load-bearing performance. Check whether there are sundries in the chute to prevent it from sliding normally. First, clean the debris in the chute to see if it can slide normally. If not, check the chute for rust. In this case, add some lubricant to the chute or remove rust from the chute.

這時，還需要檢查輪滑的受損程度是否嚴重。可以拆換有問題的部件，或直接拆換整個輪子，使玻璃門恢復正常工作狀態。

At this time, it is also necessary to check whether the damage of the roller slide is serious. The defective parts can be replaced, or the entire wheel can be directly replaced to restore the glass door to its normal working state.

四、門關不嚴

4、 The door is not closed tightly

在使用玻璃門時，常見的問題是門關不上，或者門關閉時，對不上正確的位置上，出現偏差。查看玻璃門夾是否松動，松動就可以加一個到兩個皮墊子，用螺絲刀擰緊。倘若玻璃門夾壞了，拆換玻璃門夾。然后再調節閉門器的液壓閥，閉門器關門力量太小也會導致門關不嚴。

When using glass doors, the common problem is that the door cannot be closed, or when the door is closed, it cannot be aligned to the correct position, resulting in deviation. Check whether the glass door clamp is loose. If it is loose, one or two leather cushions can be added and tightened with a screwdriver. If the glass door clip is damaged, remove and replace the glass door clip. Then adjust the hydraulic valve of the door closer. If the closing force of the door closer is too small, the door will not be closed tightly.

五、玻璃門框以及玻璃門固定框出問題

5、 There is a problem with the glass door frame and its fixing frame

玻璃門框以及玻璃門固定框使用時間過長，可能會出現磨損。倘若磨損程度大，玻璃需要拆卸下來處理，這將是一項大工程。這類問題，小編建議大家咨詢專門的玻璃門維修店維修，或是拆換玻璃門框或是玻璃門固定門框。

The glass door frame and the glass door fixing frame may be worn if they are used for a long time. If the wear degree is large, the glass needs to be disassembled for treatment, which will be a big project. For this kind of problem, I suggest you consult a special glass door repair shop for maintenance, or replace the glass door frame or fix the glass door frame.

定期檢查玻璃門的小部件，如輪滑，路軌清理等。若采用推拉開合方式，應定期上潤滑油，使玻璃門開合更平穩流暢。更多相關內容歡迎來我們網站http://www.taomeishi.com.cn進行咨詢了解！

Regularly check the small parts of glass door, such as wheel slide, rail cleaning, etc. If the sliding opening and closing mode is adopted, lubricating oil shall be applied regularly to make the glass door open and close more smoothly. Welcome to our website for more information http://www.taomeishi.com.cn Ask about it!